This electronic part is conveniently packaged in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width), making it easy to ship abroad. This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). There is an analog multiplexer mounted in position Surface Mount. There is 1:1 ratio between the number of multiplexers and demultiplexers. Operational temperature extended around -40°C~125°C TA. In total, there have been 8 terminations. High-quality output is provided by the electronic component's 1 channels. An 5V voltage supply should allow the electrical part to be turned on and run. A key feature of the 8 series is the inclusion of this electronic part as part of its design. SPST - NC switching circuits are used in these analog switch ics. Search with ADG1402 if you are looking for analog multiplexer variants. Analog switches have 1.3Ohm internal resistance. For details about the functions of 8 pins, please refer to the datasheets. This switch device is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 16.5V. An effective Dual, Single supply digital multiplexer. The lowest voltage fed to the electronic component should be 5V. This multiplexer would work with 60μA current. If you put voltage higher than 95μA on the digital multiplexer, damage may occur. There is no problem with using dual supply voltage, but it should not exceed 16.5V. With dual power supplies, you should attach at least 4.5V. A voltage of 12V can be used to operate the electronic component. A 1 input needs to be operated. There are 120MHz bandwidths for data transfer.