This electronic part is conveniently packaged in 10-TFSOP, 10-MSOP (0.118, 3.00mm Width), making it easy to ship abroad. This packaging method provides high reliability because it uses advanced packaging techniques. In Surface Mount, you'll find this switch device. 1:1 is the ratio between multiplexers and demultiplexers. Operating temperature around -40°C~125°C TA extended. By its 2 channels, the electronic component provides high-quality output. A SPST - NC switching circuit is used for these analog switches. A 2 circuit is present in this switch device. Look for analog switch ic variants by searching with ADG1422. Internally, this switch multiplexer has a resistance of 2.4Ohm. The datasheets for the 10 pins explain the functions. It is normally recommended that users do not supply the multiplexer with voltages higher than 16.5V. A analog switch ic that has a cost-effective Dual, Single supply type. 5V should be the lowest voltage fed to the electronic component. It would be sufficient to run this analogue multiplexer with 120μA current. A digital multiplexer may suffer damage if voltage is applied above 190μA. Dual supply volatge is feasible for this multiplexer. But it should not go beyond 16.5V. When using dual power supplies, you should attach at least 4.5V. A voltage of 12V can be used to operate the electronic component. Among the inputs that can be operated are the 2 inputs. There are various bandwidths available for data transfer. The switches should not operate in an environment where the temperature is higher than 125°C. This digital multiplexer has 2 outputs. Suppliers are offering a 10-MSOP package.