This electronic part is conveniently packaged in 16-VQFN Exposed Pad, CSP, making it easy to ship abroad. This packaging method provides high reliability because it uses advanced packaging techniques. In Surface Mount, you'll find this switch device. The ratio between the number of multiplexer and demultiplexer circuits is 2:1. Extended operating temperature around -40°C~125°C TA. Totally, there are 16 terminations. A high-quality output is provided by the electrical component's 1 channels. In the case of a voltage supply of 5V volts, the electrical part can be powered up and run. 16 pins are injected to the electronic part body. These analog multiplexers are built based on SPDT switching circuits. Look for analog switch ic variants by searching with ADG1636. A 1.1Ohm internal resistance characterizes this multiplexer. Datasheets for 16 pin functions are available upon request. There is a standard Multiplexer or Switches analogue multiplexer here. Multiplexers should not be powered above 16V in normal situations. A cost-effective Dual, Single supply type analogue multiplexer. 3.3V is the lowest voltage that should be fed to the electronic electronic part. A voltage higher than 360μA may cause damage to the switch multiplexer. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 8V. In the case of dual power supplies, you should connect at least 3.3V. Integrated with SPST analog IC. There are 2 inputs to be operated. 25MHz-bandwidths can be used to transfer data between multiplexers. In this digital multiplexer, there are 4 outputs.