The electronic part can be shipped overseas conveniently because it is packaged in 16-TSSOP (0.173, 4.40mm Width). High reliability is achieved by using advanced packaging method Tape & Reel (TR). In Surface Mount, this analog switch is mounted. 1:1 is the number of circuits in the multiplexer and demultiplexer. Operation at a temperature around -40°C~85°C TA. The total number of terminations is 16. A 4 channel electronic part produces high-quality output. In the case of a voltage supply of 15V volts, the electrical part can be powered up and run. This electronic part can be found in the 16 series. A SPST - NC switching circuit is used to build these analog multiplexers. Look for analog switch ic variants by searching with ADG411. In this multiplexer, the internal resistance is 35Ohm. The datasheets for the 16 pins explain the functions. The analogue multiplexer in this example is a typical Multiplexer or Switches. Users should never supply a voltage higher than 25V to a switch device. Digital switch that provides Dual, Single power at a cost-effective price. A low voltage of 5V should be applied to the electronic component. This digital switch can be operated with a current of 100pA. It may damage the digital multiplexer if the voltage is higher than 1μA. There is no problem with using dual supply voltage, but it should not exceed 22V. It is recommended that you attach at least 13.5V to your dual power supply. A voltage of 12V can be used to operate the electronic component. There is also ALSO OPERATE WITH 12V SINGLE SUPPLY to look out for in this electronic part.
ADG411BRU-REEL7 Features
4 Channels Switch Circuit: SPST - NC 100pA Supply Current Additional Features: ALSO OPERATE WITH 12V SINGLE SUPPLY
ADG411BRU-REEL7 Applications
There are a lot of Analog Devices Inc. ADG411BRU-REEL7 Analog Switches & Multiplexers ICs applications.