Due to its 8-SOIC (0.154, 3.90mm Width) packaging, the electronic part is convenient for international shipping. High reliability is ensured by the advanced packaging method Tube. Multiplexers like this are mounted in the Surface Mount position. 2:1 is the number of circuits in the multiplexer and demultiplexer. Around -40°C~125°C TA is the extended operating temperature. Total terminations are 8. A electrical component with 1 channels is capable of high-quality output. If the voltage supply is 15V volts, the electrical component should be turned on and run. This electronic part can be found in the 8 series. These analog multiplexers are built based on SPDT switching circuits. Try searching with ADG419 if you're looking for variants. It has an internal resistance of 35Ohm. Datasheets for functions of 8 pins are available. A analogue multiplexer of this type is a Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 25V. Analog switch ics with Dual, Single supply type are cost-effective. The lowest voltage the electronic part should receive is 5V. In order to operate this switch device, it would need a current of 100pA. A voltage higher than 1μA may cause damage to the switch multiplexer. Despite this switch's dual supply capability, its voltage should not exceed 22V. If you are using dual power supplies, you should attach at least 13.5V. This electrical part is compatible with 12V operating voltages. A Drain to Source resistance of 25mOhm is shown for this electronic part. The analog switch ics includes 2 outputs.