Packed in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width), the electronic component is convenient for shipping overseas. This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). In Surface Mount, you'll find this switch device. Multiplexers and demultiplexers have the same number of circuits 2:1. Extended operating temperature around -55°C~125°C TA. Total terminations are 8. As a result of its 1 channels, this electronic component provides high-quality output. It is safe to turn on and run the electronic component with a 15V voltage supply. An electrical component like this is included in the 8 series. On the other hand, analog switches can be constructed using SPDT switching circuits. This multiplexer is composed of 1 circuits. Try searching with ADG419 if you're looking for variants. An switch multiplexer with 35Ohm internal resistance has a value of 35Ohm. The functions of 8 pins can be found in the datasheets. Multiplexer or Switches is a typical switch device. It is generally not recommended to supply a voltage higher than 13.2V to the switch device in normal circumstances. Dual, Single supply type digital switch with a low cost. A low voltage of 5V should be applied to the electronic component. If you put voltage higher than 1μA on the digital multiplexer, damage may occur. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 16.5V. You should attach at least 13.5V voltage if you are using dual power supply. 12V operating voltages can be used with this electrical part. This electronic component presents a Drain to Source resistance of 35Ohm.