ADG432BNZ Overview

Presented in 16-DIP (0.300, 7.62mm), this electrical component is convenient for overseas shipping. Advanced packaging method Tube is used to provide high reliability. There is an analog multiplexer mounted in position Through Hole. 1:1 is the number of circuits in the multiplexer and demultiplexer. Operational temperature extended around -40°C~85°C TA. Total terminations are 16. A high-quality output is provided by the electrical component's 4 channels. An 15V voltage supply should allow the electrical part to be turned on and run. A total of 16 pins are injected into the electrical part body. A SPST - NO switching circuit is used for these analog switches. Use ADG432 to search for variants of the digital switches. There is 24Ohm internal resistance in this digital multiplexer. Please refer to the datasheets for 16 pins functions. It is normally recommended that users do not supply the multiplexer with voltages higher than 25V. 5V is the lowest voltage that should be fed to the electronic electronic part. It would be sufficient to run this analogue multiplexer with 100pA current. If put voltage greater than 100nA on the device, damage may be caused to the analogue multiplexer. If put voltage greater than 22V on the multiplexer, damage may be caused to the device. There is a voltage range of 12V operating voltages for the electrical part.

ADG432BNZ Features

4 Channels
Switch Circuit: SPST - NO
100pA Supply Current

ADG432BNZ Applications

There are a lot of Analog Devices Inc. ADG432BNZ Analog Switches & Multiplexers ICs applications.

• Modems
• Low-Voltage
• Optical Applications
• Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
• Medical Instrumentation
• Multiplexers
• Signal routing between systems
• Ultrasound
• SDH
• Medical