ADG451BRZ Overview

This electronic part is conveniently packaged in 16-SOIC (0.154, 3.90mm Width), making it easy to ship abroad. High reliability is achieved by using advanced packaging method Tube. The multiplexer is located in Surface Mount. Multiplexers and demultiplexers have a ratio of 1:1. Extended operating temperature around -40°C~85°C TA. Total terminations are 16. The electronic part delivers high-quality output through its 4 channels. If the voltage supply is 5V volts, the electrical component should be turned on and run. It is injected into the electrical part body with 16 pins. These analog multiplexers are built based on SPST - NC switching circuits. Try searching with ADG451 if you're looking for variants. An switch multiplexer with 5Ohm internal resistance has a value of 5Ohm. Please refer to the datasheets for 16 pins functions. There is Multiplexer or Switches analog multiplexer like this in the world. An abnormal situation would be for the switch device to be supplied with a voltage greater than 15V. In order for the electronic part to function properly, the lowest voltage should be 5V. If put voltage greater than 500nA on the device, damage may be caused to the analogue multiplexer. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 20V. It is recommended that you attach at least 4.5V to your dual power supply. A voltage of 9V can be used to operate the electronic component. Drain to Source resistance for this electronic component is 4mOhm.

ADG451BRZ Features

4 Channels
Switch Circuit: SPST - NC
Drain-to-Source resistance: 4mOhm

ADG451BRZ Applications

There are a lot of Analog Devices Inc. ADG451BRZ Analog Switches & Multiplexers ICs applications.

• Audio/video switches
• CSU
• Remote wireless modules
• FTTH
• Cable Modem
• Multiplexers
• RGB switches
• Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
• Cell phones
• Sample-and-hold systems