Shipping overseas is convenient due to the electrical component's packing in 16-TSSOP (0.173, 4.40mm Width). To ensure high reliability, a new packaging method Tube is used. In Surface Mount, you'll find this switch device. Multiplexer and demultiplexer circuits have a number 1:1. Extended operating temperature around -40°C~125°C TA. In total, there are 16 terminations. The electronic part delivers high-quality output through its 1 channels. When a voltage supply of 15V is used, the electronic component should be turned on and run. There is an electrical component included in the 16 series. SPST - NO/NC switching circuits are used in these analog switch ics. Use ADG5213 to search for variants of the digital switches. The internal resistance of this digital multiplexer is 160Ohm. The functions of 16 pins can be found in the datasheets. A analogue multiplexer of this type is a Multiplexer or Switches. Multiplexers should not be powered above 40V in normal situations. The digital multiplexer has a low cost Dual, Single supply. There should be 9V voltage fed to the electrical part below 9V. A voltage higher than 55μA may cause damage to the switch multiplexer. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 22V. When using dual power supplies, you should attach at least 9V. The digital multiplexer has SEPARATE OUTPUT outputs that can be used. A 4 input needs to be operated. There are various bandwidths available for data transfer. Drain to Source resistance for this electronic component is 160Ohm.