ADG5249FBRUZ Overview

Packed in 20-TSSOP (0.173, 4.40mm Width), the electronic component is convenient for shipping overseas. High reliability is ensured by the advanced packaging method Tube. Surface Mount is where this multiplexer is located. Multiplexers and demultiplexers have a ratio of 4:1. Around -40°C~125°C TA is the extended operating temperature. In total, there have been 20 terminations. High-quality output is provided by the electronic component's 4 channels. An 15V voltage supply should allow the electrical part to be turned on and run. This electronic part can be found in the 20 series. Circuits based on SP4T switching are used to construct these analog switch ics. Circuits number 2 make up this analogue multiplexer. Try searching with ADG5249 to find analog multiplexer variants. An switch multiplexer with 335Ohm internal resistance has a value of 335Ohm. Please refer to the datasheets for 20 pins functions. Users shouldn't supply more than 44V voltage to the switch device. It is recommended that the electrical component receives a voltage of 8V. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 22V. The voltage should be at least 5V if you are using dual power supplies. An analog IC with the number DIFFERENTIAL MULTIPLEXER is integrated into this board.

ADG5249FBRUZ Features

4 Channels
Switch Circuit: SP4T
-3db Bandwidth: 320MHz

ADG5249FBRUZ Applications

There are a lot of Analog Devices Inc. ADG5249FBRUZ Analog Switches & Multiplexers ICs applications.

• Signal routing between systems
• E1 Multiplexer
• Industrial and process control systems
• Relay Replacement
• Data switching
• DSLAMs
• PDAs
• Access Concentrators
• Central office
• E1 Network Equipment