ADG611YRUZ-REEL Overview

As the electronic part is packed in 16-TSSOP (0.173, 4.40mm Width), international shipping is convenient. To ensure high reliability, a new packaging method Tape & Reel (TR) is used. Multiplexers like this are mounted in the Surface Mount position. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Operating temperature around -40°C~125°C TA extended. In total, there have been 16 terminations. High-quality output is provided by the electronic component's 4 channels. If the voltage supply is 5V volts, the electrical component should be turned on and run. 16 pins are injected to the electronic part body. Circuits based on SPST - NC switching are used to construct these analog switch ics. Try searching with ADG611 to find analog multiplexer variants. A 115Ohm internal resistance characterizes this multiplexer. Datasheets for functions of 16 pins are available. Theswitch device is a typical Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 5.5V. The lowest voltage fed to the electronic component should be 2.7V. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 5.5V. In the case of dual power supplies, you should connect at least 2.7V. The digital multiplexer has SEPARATE OUTPUT outputs that can be used.

ADG611YRUZ-REEL Features

4 Channels
Switch Circuit: SPST - NC
-3db Bandwidth: 680MHz

ADG611YRUZ-REEL Applications

There are a lot of Analog Devices Inc. ADG611YRUZ-REEL Analog Switches & Multiplexers ICs applications.

• Existing multiplexer applications (both fault-protected and nonfault-protected)
• Channel Banks
• Microprocessor Controlled Analog Systems
• Precision instrumentation
• SONET/SDH ADM
• Sample-and-hold systems
• Medical
• Channelized and Unchannelized DS3 applications
• Optical Applications
• Audio and video routing