ADG612YRUZ Overview

Shipping overseas is convenient with the electronic component packed in 16-TSSOP (0.173, 4.40mm Width). The advanced packaging method Tube provides high reliability. A switch device like this is mounted in Surface Mount. Multiplexers and demultiplexers have a ratio of 1:1. Operational temperature extended around -40°C~125°C TA. Total terminations are 16. This electronic part offers high-quality output due to its 4 channels. Powered by a 5V voltage supply, the electrical part should be switched on and run. 16 pins are injected to the electronic part body. A SPST - NO switching circuit is used to build these analog multiplexers. If you are looking for variants of the digital switch, trying search with ADG612. The internal resistance of this digital multiplexer is 115Ohm. To find out what the 16 pins do, please refer to the datasheets. Theswitch device is a typical Multiplexer or Switches. In normalcircumstances, users should not exceed 5.5V volts for the multiplexer. The digital multiplexer has a low cost Dual, Single supply. It is recommended to use 2.7V as the lowest voltage for the electrical part. For this multiplexer to operate, 1nA current would be sufficient. Put voltage above 1μA on the multiplexer to cause damage. There is no problem with using dual supply voltage, but it should not exceed 5.5V. In the case of dual power supplies, you should connect at least 2.7V. There are 680MHz bandwidths for data transfer. This electronic component presents a Drain to Source resistance of 85Ohm.

ADG612YRUZ Features

4 Channels
Switch Circuit: SPST - NO
1nA Supply Current
Bandwidth: 680MHz
Drain-to-Source resistance: 85Ohm

ADG612YRUZ Applications

There are a lot of Analog Devices Inc. ADG612YRUZ Analog Switches & Multiplexers ICs applications.

• Imaging
• SONET
• High speed data transmission line cards
• Precision instrumentation
• FTTH
• Voice over IP/DSL – Integrated Access Devices, Smart
• Multi-Line E1 Interface Cards
• CSU
• Battery Powered Systems
• Avionics test equipment