Shipping overseas is convenient with the electronic component packed in 16-TSSOP (0.173, 4.40mm Width). High reliability is provided by advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. Multiplexers and demultiplexers have a number of circuits 1:1. Operating temperature around -40°C~125°C TA extended. Total terminations are 16. By its 4 channels, the electronic component provides high-quality output. If the voltage supply is 5V volts, the electrical component should be turned on and run. It is part of the design of the 16 series that this electronic component is included. Unlike digital switches, these are based on SPST - NO/NC switching circuits. Try searching with ADG613 if you're looking for variants. The internal resistance of this digital multiplexer is 115Ohm. To find out what the functions of 16 pins are, please refer to their datasheets. Theswitch device is a typical Multiplexer or Switches. Multiplexers should not be powered above 5.5V in normal situations. Digital switch that provides Dual, Single power at a cost-effective price. The lowest voltage the electronic part should receive is 2.7V. An operating current of 1nA would be sufficient for this switch device. A digital multiplexer may suffer damage if voltage is applied above 1μA. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 5.5V. With dual power supplies, you should attach at least 2.7V. The analog switch ic utilizes SEPARATE OUTPUT outputs in total. There are 680MHz bandwidths for data transfer.