ADG702BRJZ-REEL7 Overview

The electronic part can be shipped overseas conveniently because it is packaged in SC-74A, SOT-753. High reliability is achieved by using advanced packaging method Tape & Reel (TR). Mounted in Surface Mount is this multiplexer. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Operation at a temperature around -40°C~85°C TA. In total, there are 5 terminations. By its 1 channels, the electronic component provides high-quality output. With a 3V voltage supply, the electrical component should be turned on and run. An injection of 5 pins is performed into the body of the electrical component. A SPST - NC switching circuit is used for these analog switches. Look for analog switch ic variants by searching with ADG702. The internal resistance of this digital multiplexer is 3Ohm. Datasheets for 5 pin functions are available upon request. There is a standard Multiplexer or Switches analogue multiplexer here. normally, users should not supply switches with voltages higher than 5.5V. 1.8V is the lowest voltage the electrical component should receive. A voltage of 1.8V~5V is required to drain this analog switch from a single voltage supply. A voltage higher than 1μA may cause damage to the switch multiplexer. The data can be transferred over a wide range of bandwidths, called 200MHz bandwidths.

ADG702BRJZ-REEL7 Features

1 Channels
Switch Circuit: SPST - NC
Bandwidth: 200MHz

ADG702BRJZ-REEL7 Applications

There are a lot of Analog Devices Inc. ADG702BRJZ-REEL7 Analog Switches & Multiplexers ICs applications.

• Cell phones
• High reliability control systems
• Central office
• Audio and video signal routing
• Power routing
• Cellular phones
• Cable Telephony – NIU, Set-Top Box, Home Side Box
• Fiber In The Loop (FITL)
• Battery Powered Instruments
• Fiber to the Home