ADG702LBRMZ-REEL Overview

Packed in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width), the electronic component is convenient for shipping overseas. The advanced packaging method Tape & Reel (TR) provides high reliability. Mounted in Surface Mount is this multiplexer. Multiplexer and demultiplexer circuits have a number 1:1. Extended operating temperature around -40°C~85°C TA. A total of 8 terminations have been recorded. High-quality output is provided by the electronic component's 1 channels. In the case of a voltage supply of 3V volts, the electrical part can be powered up and run. It is part of the design of the 8 series that this electronic component is included. On the other hand, analog switches can be constructed using SPST - NC switching circuits. If you are looking for variants of the digital switch, trying search with ADG702. An switch multiplexer with 3Ohm internal resistance has a value of 3Ohm. Datasheets for 8 pin functions are available upon request. Multiplexer or Switches is a typical switch device. Users should never supply a voltage higher than 5.5V to a switch device. A low voltage of 1.8V should be applied to the electronic component. This analogue multiplexer requires a voltage of 1.8V~5V when it drains from a single voltage supply. When the digital multiplexer is charged above 1pA, damage can occur. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer.

ADG702LBRMZ-REEL Features

1 Channels
Switch Circuit: SPST - NC
-3db Bandwidth: 200MHz

ADG702LBRMZ-REEL Applications

There are a lot of Analog Devices Inc. ADG702LBRMZ-REEL Analog Switches & Multiplexers ICs applications.

• SONET/SDH ADM
• Data switching
• Sample hold systems
• Intelligent PBX
• High reliability control systems
• High-Voltage
• SDH/SONET multiplexers
• Avionics and Military Systems
• Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
• DSLAMs