ADG711BRU-REEL7 Overview

Presented in 16-TSSOP (0.173, 4.40mm Width), this electrical component is convenient for overseas shipping. High reliability is provided by advanced packaging method Tape & Reel (TR). A switch device like this is mounted in Surface Mount. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. An extended operating temperature of -40°C~85°C TA degrees Celsius. In total, there have been 16 terminations. A 4 channel electronic part produces high-quality output. With a 3V voltage supply, the electrical component should be turned on and run. This electrical component is included in the 16 series of products. The analog switch ics are built using SPST - NC switching circuits. Try searching for ADG711 variants of the analog switch ic. A 4Ohm internal resistance characterizes this multiplexer. Please refer to the datasheets for 16 pins functions. A analogue multiplexer of this type is a Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 5.5V. The lowest voltage the electronic part should receive is 1.8V. This analog switch requires a voltage of 1.8V~5.5V to drain from a single voltage supply. The analogue multiplexer may be damaged if voltage is greater than 1μA. SEPARATE OUTPUT outputs are utilized by this digital multiplexer. Check out the electrical component's additional features, such as the following: CAN ALSO OPERATE WITH 5 V SUPPLY.

ADG711BRU-REEL7 Features

4 Channels
Switch Circuit: SPST - NC
-3db Bandwidth: 200MHz
Additional Features: CAN ALSO OPERATE WITH 5 V SUPPLY

ADG711BRU-REEL7 Applications

There are a lot of Analog Devices Inc. ADG711BRU-REEL7 Analog Switches & Multiplexers ICs applications.

• ISDN NT1/TA
• High speed data transmission line cards
• PBXs
• Cellular phones
• Precision test equipment
• Microprocessor Controlled Analog Systems
• Communication systems
• Frame Relay Equipment
• Audio signal routing
• Signal routing between systems