Shipping overseas is convenient with the electronic component packed in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width). Advanced packaging method Tube is used to provide high reliability. The multiplexer is located in Surface Mount. Multiplexer and demultiplexer circuits have a number 2:1. The operating temperature is extended to around -40°C~125°C TA. Total terminations are 8. A high-quality output is provided by the electrical component's 1 channels. With a 3V voltage supply, the electrical component should be turned on and run. A key feature of the 8 series is the inclusion of this electronic part as part of its design. A SPDT switching circuit is used for these analog switches. ADG719 can be used to search for analog multiplexer variants. A 4Ohm internal resistance characterizes this multiplexer. For functions related to 8 pins, please refer to the datasheets. There is Multiplexer or Switches analog multiplexer like this in the world. A voltage higher than 5.5V should not normally be supplied to the switches. It is recommended that the electrical component receives a voltage of 1.8V. This digital switch can be operated with a current of 1nA. This analogue multiplexer requires a voltage of 1.8V~5.5V when it drains from a single voltage supply. The analogue multiplexer may be damaged if voltage is greater than 1μA. There are various bandwidths available for data transfer. A Drain to Source resistance of 2.5Ohm is shown for this electronic part. A analog switch ics with 2 outputs is included.