ADG729BRUZ-REEL7 Overview

The electronic part can be shipped overseas conveniently because it is packaged in 16-TSSOP (0.173, 4.40mm Width). This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). Surface Mount is where this multiplexer is located. There is 4:1 ratio between the number of multiplexers and demultiplexers. Operational temperature extended around -40°C~85°C TA. Total terminations are 16. As a result of its 4 channels, this electronic component provides high-quality output. An 3V voltage supply should allow the electrical part to be turned on and run. This electrical component is included in the 16 series of products. Circuits based on SP4T switching are used to construct these analog switch ics. Circuits number 2 make up this analogue multiplexer. Use ADG729 to search for variants of the digital switches. There is 4.5Ohm internal resistance in this digital multiplexer. You can find the functions of the 16 pins in the datasheets. Users shouldn't supply more than 5.5V voltage to the switch device. Analogue multiplexer with a Single supply type that is cost-effective. 2.7V is the lowest voltage that should be fed to the electronic electronic part. In order to operate this switch device, it would need a current of 10μA. An analogue multiplexer drains from a single voltage supply at 2.7V~5.5V. Putting voltage greater than 20μA on the multiplexer may cause damage. An analog IC with the number AUDIO/VIDEO SWITCH is integrated into this board. Among the inputs that can be operated are the 8 inputs. The data can be transferred over a wide range of bandwidths, called 100MHz bandwidths. It conducts in a 4-bit manner.

ADG729BRUZ-REEL7 Features

4 Channels
Switch Circuit: SP4T
10μA Supply Current
Bandwidth: 100MHz
4-Bit

ADG729BRUZ-REEL7 Applications

There are a lot of Analog Devices Inc. ADG729BRUZ-REEL7 Analog Switches & Multiplexers ICs applications.

• PBX interfaces
• Wireless Local Loop
• DSUs
• Modems
• ISDN NT1/TA
• Fault Tolerant Systems
• Relay Replacement
• Microwave transmission systems
• ATM
• Battery-powered systems