The electronic part can be shipped overseas conveniently because it is packaged in 16-TSSOP (0.173, 4.40mm Width). A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). In Surface Mount, this analog switch is mounted. Multiplexers and demultiplexers have a number of circuits 2:1. An extended operating temperature of -40°C~85°C TA degrees Celsius. There are 16 terminations totally. The electronic part provides high-quality output because it has 3 channels. An 2.5V voltage supply should allow the electrical part to be turned on and run. 16 pins are injected to the electronic part body. These analog multiplexers are built based on SPDT switching circuits. Try searching with ADG733 to find analog multiplexer variants. In this multiplexer, the internal resistance is 4.5Ohm. Datasheets for functions of 16 pins are available. Theswitch device is a typical Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 5.5V. Dual, Single supply type digital switch with a low cost. A low voltage of 1.8V should be applied to the electronic component. An operating current of 1nA would be sufficient for this switch device. If you put voltage higher than 1μA on the digital multiplexer, damage may occur. For this multiplexer, dual supply voltage is feasible, but it should not exceed 2.75V. With dual power supplies, you should attach at least 2.25V. It is possible to transfer data over a 160MHz-bandwidth. Don't forget the additional features of this electronic part, such as: ALSO OPERATES WITH 1.8V TO 5.5V SINGLE SUPPLY. The analog switch ics has 6 outputs.
ADG733BRUZ-REEL Features
3 Channels Switch Circuit: SPDT 1nA Supply Current -3db Bandwidth: 200MHz Bandwidth: 160MHz Additional Features: ALSO OPERATES WITH 1.8V TO 5.5V SINGLE SUPPLY
ADG733BRUZ-REEL Applications
There are a lot of Analog Devices Inc. ADG733BRUZ-REEL Analog Switches & Multiplexers ICs applications.