Presented in 20-WFQFN Exposed Pad, CSP, this electrical component is convenient for overseas shipping. To ensure high reliability, a new packaging method Tray is used. The multiplexer is located in Surface Mount. Multiplexers and demultiplexers have a ratio of 1:1. Increasing operating temperature to around -40°C~85°C TA. There are 20 terminations totally. A electrical component with 4 channels is capable of high-quality output. In the case of a voltage supply of 3V volts, the electrical part can be powered up and run. It is part of the design of the 20 series that this electronic component is included. These analog multiplexers are built based on SPST - NC switching circuits. If you are looking for variants of the digital switch, trying search with ADG781. This digital multiplexer has 4Ohm internal resistance. The functions of 20 pins can be found in the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. A voltage higher than 5.5V should not normally be supplied to the switches. The lowest voltage the electronic part should receive is 1.8V. Analogue multiplexers require a 1.8V~5.5V voltage to drain from a single voltage supply. Put voltage above 1μA on the multiplexer to cause damage. The data can be transferred over a wide range of bandwidths, called 200MHz bandwidths. Don’t miss additional features of the electronic component such as: CAN ALSO OPERATE AT 5V NOMINAL.
ADG781BCPZ Features
4 Channels Switch Circuit: SPST - NC Bandwidth: 200MHz Additional Features: CAN ALSO OPERATE AT 5V NOMINAL
ADG781BCPZ Applications
There are a lot of Analog Devices Inc. ADG781BCPZ Analog Switches & Multiplexers ICs applications.