Presented in 20-WFQFN Exposed Pad, CSP, this electrical component is convenient for overseas shipping. High reliability is achieved by using advanced packaging method Tray. It is mounted in the position Surface Mount. Multiplexer and demultiplexer circuits have a number 2:1. Around -40°C~85°C TA is the extended operating temperature. A total of 20 terminations have been recorded. A electrical component with 3 channels is capable of high-quality output. Powered by a 2.5V voltage supply, the electrical part should be switched on and run. Electronic part bodies are injected with 20 pins. Based on SPDT switching circuits, these analog multiplexers work. Using the ADG786 search parameter, you can discover variants of the switch. There is 4.5Ohm internal resistance in this digital multiplexer. Datasheets for 20 pin functions are available upon request. Multiplexer or Switches is a typical switch device. It is generally not recommended to supply a voltage higher than 5.5V to the switch device in normal circumstances. A analog switch ic that has a cost-effective Dual, Single supply type. 1.8V should be the lowest voltage fed to the electronic component. If put voltage greater than 1μA on the device, damage may be caused to the analogue multiplexer. Despite this switch device's dual supply capability, its voltage should not exceed 2.75V. With dual power supplies, you should attach at least 2.25V. A 160MHz-bandwidth can be used for data transfer. A Drain to Source resistance of 4.5Ohm is shown for this electronic part. This digital multiplexer has 6 outputs.