ADP1872ARMZ-0.6-R7 Overview

As a result of 10-TFSOP, 10-MSOP (0.118, 3.00mm Width) compact design, the switching controller is compatible with most applications. This dc motor controller can be used to generate outputs with 1 numbers. An enclosure of Tape & Reel (TR) is used to package the PMIC. Transistor Driver dc switching's outputs (s) can be handled by it. 2.75V~20V is the supply voltage and the operating voltage of the dc control. Qualified to work in an dc switcher with -40°C~125°C TJ. It is suitable for general dc dc regulator when it is set to Surface Mount. Enable provides dcdc regulator efficient switching control. Thare switch converters are connected to an analog integrated circuit (IC) of type SWITCHING CONTROLLER. The switching converters's terminal (s) are designed at DUAL . The 10 terminations can be used for a wide range of dc switching. These dc dc converter ics adapt a variety of control techniques, including PULSE WIDTH MODULATION. There is a DC switcher's nominal voltage of 12V. You can find other relevant dc to dc converter ics by searching "ADP1872". There are a total of 10 pins on switching converter. In particular, switching converter belongs to the Switching Regulator or Controllers family. As determined by the test statistics, the output voltage of DC regulator is 600mV. In most cases, the output current of the dc dc regulator will be 25A, so note that when you start the project. As a result of this, the maximum duty cycle of the voltage regulator dc to dc must remain 65 % during power-up and power-down. DC switcher's Surface Mount qualifies it for most applications and prototypes. Switching controller operates at a frequency of 600kHz. In order to satisfy the need, DC to DC voltage regulator has a value of MINIMUM OUTPUT VOLTAGE 0.6V. To run the voltage regulator dc to dc safely and reliably, users should apply 5.5V to the voltage regulator dc to dc. It is possible to set the input voltage to 13V for nominal working status. In order to limit the voltage of a dc switcher whose maximum input voltage is 5.5V, it must be limited by the user. Voltage 2.75V is necessary for the supply. There will be 25A output current greater than 25A from the dc switcher. As per its datasheet, the switching converter has a maximum output of 4.67V volts. A current of 140μA is supplied to it. 600mV voltage output is lower than 600mV. The nominal current supply of this the controllers dc is 70mA.

ADP1872ARMZ-0.6-R7 Features

Transistor Driver Outputs
Enable
PULSE WIDTH MODULATION
Max Duty Cycle: 65 %
Frequency: 600kHz
MINIMUM OUTPUT VOLTAGE 0.6V

ADP1872ARMZ-0.6-R7 Applications

There are a lot of Analog Devices Inc. ADP1872ARMZ-0.6-R7 DC to DC converter applications.

• Low output voltage switching power supply circuits
• Electric heating, lighting
• SMT equipment
• Balance equipment
• Lathes
• Household control circuits
• Game consoles
• Packaging
• Wind power
• Correction machines