OP42GPZ Overview

Packaged in a 8-DIP (0.300, 7.62mm) case, the buffer op amp is ready to use. An op amp ic of the J-FET type. The op amp is delivered to you in a Tube case. There is a growing number of terminations approaching the number of 8. The pins on this board total to 8 in total. I would like to remind you that this buffer op amp should be powered by an 15V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. A total of 8 pins are present on the instrumentation amplifier. There is an input offset voltage of 1.2mV for this buffer op amp. The mounting type that is recommended for this electrical part is Through Hole. In relation to the operating temperature of this buffer op amp, it works well at an average of -40°C~85°C . As long as the supply current of the chip does not exceed 6.5mA, this op amp ic can operate. 119.08dB should remain the voltage gain. As far as the device is concerned, buffer amplifier has 1 channels. Currently, linear amplifier is operating with a quiescent current of 5.1mA.

OP42GPZ Features

8 Pins
supply voltage of 15V
119.08dB voltage gain

OP42GPZ Applications

There are a lot of Analog Devices Inc.
OP42GPZ Instrumentational OP Amps applications.

• Integrator circuits
• Differentiator circuits
• Logarithmic operation circuits
• Exponential operation circuits
• Multiplication circuits
• Division circuits
• Precision measurement
• Power control
• Information processing
• Weak signal detection