LT1012DJ8 Overview
The linear amplifier is packaged in a 8-CDIP (0.300, 7.62mm) case. The instrumentation amplifier in this picture is of the General Purpose-type. As far as the packaging is concerned, buffer op amp is delivered in a Tube case. During the past two weeks, there have been close to 8 terminations. The total number of pins on linear amplifier is 8. It would be helpful if you could remember that this op amp ic should be powered by an 15V battery. Instrumentation amplifier is a part of Operational Amplifiers. The mounting type that is recommended for this electrical part is Through Hole. It is recommended that this op amp ic be operated at a temperature no higher than 0°C~70°C for optimal performance. The buffer amp consists of 1 circuits in total. For optimal performance, this electrical part should be connected to a supply with a current of 380μA.
LT1012DJ8 Features
8 Pins
supply voltage of 15V
LT1012DJ8 Applications
There are a lot of Linear Technology/Analog Devices LT1012DJ8 Instrumentational OP Amps applications.
- Video computer boards
- Inverse/same-phase proportional circuit
- Signal filtering
- Medical instruments
- Test equipment
- Hand-held batteries
- Industrial control system
- Band-stop filter
- Video conversion and routing
- Measurements of Wheatstone bridge
