LT6600IDF-10#TRPBF Overview

Packaged in a 12-WFDFN Exposed Pad case, the buffer op amp is ready to use. An op amp of this type is a Differential-type. The case in which buffer amplifier is delivered is called a Tape & Reel (TR) case. It is estimated that there will be 12 terminations in the next few months. In this case, there are 12 pins on the board. I would like to remind you that this buffer op amp should be powered by an 5V battery. For this electronic part, it is recommended that you mount it with type Surface Mount. It is important to note that this linear amplifier works well at a temperature of -40°C~85°C when it comes to operating temperatureThere are 1 circuits on this op amp. As a result, it is recommended that a power supply of 36mA be used with this electronic part. An analog IC known as a ANALOG CIRCUIT is the other type of IC that is used in this op amp ic. Refer to this op amp ic's additional benefit: CAN ALSO OPERATE FROM A SINGLE 3V OR 5V SUPPLY.

LT6600IDF-10#TRPBF Features

12 Pins
supply voltage of 5V

LT6600IDF-10#TRPBF Applications

There are a lot of Linear Technology/Analog Devices LT6600IDF-10#TRPBF Instrumentational OP Amps applications.

• Tablets
• Thermocouples
• High speed sample
• Integrator circuits
• Signal transformation
• Car stereo
• Television
• Division circuits
• High/low-pass filter circuit
• Test and measurement instruments