LT6600IS8-10 Overview

In the package, you will find a 8-SOIC (0.154, 3.90mm Width)-case to contain the op amp ic. The instrumentation amplifier in this picture is of the Differential-type. The case in which buffer amplifier is delivered is called a Tube case. The number of terminations approaches 8. A total of 8 pins are located on this board. Please take in mind that this instrumentation amplifier should be run at 5V. For this electronic part, it is recommended that you mount it with type Surface Mount. According to the manufacturer, this buffer op amp works well at -40°C~85°C , which is a good operating temperature. On this instrumentation amplifier, there are 1 circuits that are connected together. A supply of 36mA or higher is recommended for use with this electronic part. The other types of analog IC are as follwed ANALOG CIRCUIT. I would like to draw your attention to the following extra benefit of this buffer amplifier: CAN ALSO OPERATE FROM A SINGLE 3V OR 5V SUPPLY.

LT6600IS8-10 Features

8 Pins
supply voltage of 5V

LT6600IS8-10 Applications

There are a lot of Linear Technology/Analog Devices LT6600IS8-10 Instrumentational OP Amps applications.

• Blood pressure sensors
• High/low-pass filter circuit
• Portable media players
• Industrial control system
• Measurements of Wheatstone bridge
• Large motor controllers
• Signal filtering
• Signal transformation
• Proportional counter tubes
• Medical instruments