LTC6912HGN-2#PBF Overview

There is a 16-SSOP (0.154, 3.90mm Width) case in which the instrumentation amplifier is packaged. An op amp ic of the Programmable Gain type. Linear amplifier is delivered in a Tube case. The number of terminations is approaching the 16 mark. The pins on this board total to 16 in total. I would like to remind you that this buffer op amp should be powered by an 5V battery. To be specific, this instrumentation amplifier is a type of Other Analog ICs. There are 16 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 2mV. For this electrical component, the recommended mounting type is Surface Mount, which is the most common. It is recommended that this op amp ic be operated at a temperature no higher than -40°C~125°C for optimal performance. An 2.25mA volt supply current is needed for this linear amplifier to operate. There should be no change in the voltage gain. During the manufacturing process, this buffer amplifier is divided into 2 circuits. Op amp ic has 2 channels. One of the advantages of this op amp is that it outputs Rail-to-Rail signals, which is one of its many advantages. 10MOhm is the range in which the instrumentation amplifier resistance should lie. There is also another type of analog IC used in this op amp ic that is called a ANALOG CIRCUIT-type IC.

LTC6912HGN-2#PBF Features

16 Pins
supply voltage of 5V
36dB voltage gain
Output Type: Rail-to-Rail
Resistance of 10MOhm

LTC6912HGN-2#PBF Applications

There are a lot of Linear Technology/Analog Devices LTC6912HGN-2#PBF Instrumentational OP Amps applications.

• Laptop
• Semiconductor detectors
• Communication device
• High/low-pass filter circuit
• Industrial control system
• Automatic control
• Commercial audio systems
• Measurements of Wheatstone bridge
• Instrumentation
• Test equipment