MAX14777GTP+ Overview

Shipping overseas is convenient with the electronic component packed in 20-WFQFN Exposed Pad. High reliability is achieved by using advanced packaging method Tube. Surface Mount is where this multiplexer is located. Multiplexer and demultiplexer circuits have a number 1:1. The operating temperature is extended to around -40°C~105°C TA. 20 terminations have been made so far. A electrical component with 1 channels is capable of high-quality output. An 5V voltage supply should allow the electrical part to be turned on and run. A SPST - NO switching circuit is used to build these analog multiplexers. There are 4 circuits in this switch device. Look for analog switch ic variants by searching with MAX14777. This digital multiplexer has 10Ohm internal resistance. Datasheets for 20 pin functions are available upon request. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. The digital multiplexer has a low cost Dual, Single supply. The lowest voltage fed to the electronic component should be 3V. This analogue multiplexer requires a voltage of 3V~5.5V when it drains from a single voltage supply. If you put voltage higher than 1.65mA on the digital multiplexer, damage may occur. The Beyond-the-Rails? series contains it.

MAX14777GTP+ Features

1 Channels
Switch Circuit: SPST - NO
-3db Bandwidth: 380MHz

MAX14777GTP+ Applications

There are a lot of Maxim Integrated MAX14777GTP+ Analog Switches & Multiplexers ICs applications.

• Automatic test equipment
• High reliability control systems
• FTTH
• Medical
• Transmit
• Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
• Fault Tolerant Systems
• PDH Multiplexers
• PCMCIA cards
• Automotive applications