As the electronic part is packed in 16-SOIC (0.154, 3.90mm Width), international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Tube. In Surface Mount, you'll find this switch device. 1:1 is the ratio of multiplexer to demultiplexer circuits. Increasing operating temperature to around -40°C~85°C TA. There are 16 terminations totally. The electronic part provides high-quality output because it has 4 channels. Powered by a 15V voltage supply, the electrical part should be switched on and run. There is an electrical component included in the 16 series. A SPST - NC switching circuit is used to build these analog multiplexers. Using the MAX312 search parameter, you can discover variants of the switch. In this multiplexer, the internal resistance is 10Ohm. To find out what the 16 pins do, please refer to the datasheets. A analogue multiplexer of this type is a Multiplexer or Switches. Users should never supply a voltage higher than 30V to a switch device. The digital multiplexer has a low cost Dual, Single supply. It is recommended that the electrical component receives a voltage of 4.5V. It may damage the digital multiplexer if the voltage is higher than 100pA. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 20V. For dual power supplies, a voltage of at least 4.5V should be attached. A total of SEPARATE OUTPUT outputs are available on this analog switch ic. Operating voltages of 20V are compatible with the electrical part. This electronic component presents a Drain to Source resistance of 10Ohm.