MAX325ESA+ Overview

The electronic component is convenient to ship overseas because it is packed in a 8-SOIC (0.154, 3.90mm Width). This high-reliability packaging method uses advanced packaging methods Tube. Surface Mount is where this multiplexer is located. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. Operating temperature extended to -40°C~85°C TA. Total terminations are 8. By its 1 channels, the electronic component provides high-quality output. In the case of a voltage supply of 5V volts, the electrical part can be powered up and run. An electrical component of this type can be found in the 8 series. Multiplexers built on a SPST - NO/NC switching circuit are built. The circuits in this analogue multiplexer number 2. Try searching with MAX325 if you're looking for variants. There is 60Ohm internal resistance in this digital multiplexer. Please refer to the datasheets for 8 pins functions. Users should never supply a voltage higher than 16V to a switch device. Digital switch that provides Single power at a cost-effective price. A low voltage of 2.7V should be applied to the electronic component. It would be sufficient to run this analogue multiplexer with 1μA current. Using only a single voltage supply, this analog switch requires 2.7V~16V voltage. It may damage the digital multiplexer if the voltage is higher than 1μA.

MAX325ESA+ Features

1 Channels
Switch Circuit: SPST - NO/NC
1μA Supply Current

MAX325ESA+ Applications

There are a lot of Maxim Integrated MAX325ESA+ Analog Switches & Multiplexers ICs applications.

• Video signal routing
• Modems
• Central office
• Audio and video switching
• E1 Network Equipment
• 65 V DACs
• USB 1.1 signal switching circuits
• FTTH
• Microwave transmission systems
• E1 Multiplexer