MAX329CWE+ Overview

The electrical component comes in 16-SOIC (0.295, 7.50mm Width) packaging, which makes it convenient to ship overseas. This packaging method provides high reliability because it uses advanced packaging techniques. Surface Mount is where this multiplexer is located. There is 4:1 ratio between the number of multiplexers and demultiplexers. Operating temperature extended to 0°C~70°C TA. In total, 16 terminations have occurred. As a result of its 4 channels, this electronic component provides high-quality output. When the electronic component is given a voltage of 15V, it should be turned on and run. As part of the design of the 16 series, this electronic part has been incorporated into the system. These analog multiplexers are built based on SP4T switching circuits. The circuits in this analogue multiplexer number 2. Look for analog switch ic variants by searching with MAX329. This digital multiplexer has 3.5kOhm internal resistance. To find out what the 16 pins do, please refer to the datasheets. In a normalsituation, users should not supply the switches with voltage higher than 30V. Dual, Single supply type digital switch with a low cost. 10V should be the lowest voltage fed to the electronic component. In order to operate this switch device, it would need a current of 4.5μA. Despite this switch device's dual supply capability, its voltage should not exceed 18V. If you are using a dual power supply, you should attach at least 5V. There is a voltage range of 28V operating voltages for the electrical part.

MAX329CWE+ Features

4 Channels
Switch Circuit: SP4T
4.5μA Supply Current

MAX329CWE+ Applications

There are a lot of Maxim Integrated MAX329CWE+ Analog Switches & Multiplexers ICs applications.

• Signal routing between systems
• 65 V DACs
• Transmit
• Sample hold systems
• DSUs
• E1 Network Equipment
• Ultrasound
• Existing multiplexer applications (both fault-protected and nonfault-protected)
• High-Voltage
• Multi-Line E1 Interface Cards