The electronic component is convenient to ship overseas because it is packed in a 20-SSOP (0.209, 5.30mm Width). This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). In Surface Mount, this analog switch is mounted. 2:1 is the ratio between multiplexers and demultiplexers. Extended operating temperature around 0°C~70°C TA. In total, 20 terminations have occurred. High-quality output is provided by the electronic component's 1 channels. A 5V voltage supply should turn on and run the electronic component. There is an electrical component included in the 20 series. Unlike digital switches, these are based on SPDT switching circuits. There are 4 circuits in this switch device. Try searching with MAX394 if you're looking for variants. As far as internal resistance is concerned, it has 35Ohm. To find out what the functions of 20 pins are, please refer to their datasheets. Multiplexer or Switches is a typical switch device. In normalcircumstances, users should not exceed 16V volts for the multiplexer. A analog switch ic that has a cost-effective Dual, Single supply type. It is recommended to use 2.4V as the lowest voltage for the electrical part. An operating current of 1μA would be sufficient for this switch device. Put voltage above 60nA on the multiplexer to cause damage. Despite this switch device's dual supply capability, its voltage should not exceed 8V. With dual power supplies, you should attach at least 2.4V. In this switch multiplexer, there are SEPARATE OUTPUT outputs available. 8V operating voltages are supported by the electronic component.
MAX394CAP+T Features
1 Channels Switch Circuit: SPDT 1μA Supply Current
MAX394CAP+T Applications
There are a lot of Maxim Integrated MAX394CAP+T Analog Switches & Multiplexers ICs applications.