The electrical component comes in 16-DIP (0.300, 7.62mm) packaging, which makes it convenient to ship overseas. High reliability is achieved by using advanced packaging method Tube. Through Hole is where this multiplexer is located. The ratio between the number of multiplexer and demultiplexer circuits is 4:1. Operational temperature extended around -40°C~85°C TA. Total terminations are 16. The electronic part provides high-quality output because it has 4 channels. It is safe to turn on and run the electronic component with a 5V voltage supply. It is injected into the electrical part body with 16 pins. A SP4T switching circuit is used for these analog switches. The circuits in this analogue multiplexer number 2. Try searching for the analog switch ic with MAX399 if you are looking for variants. Internally, this switch multiplexer has a resistance of 100Ohm. You can find the functions of the 16 pins in the datasheets. In a normalsituation, users should not supply the switches with voltage higher than 15V. A cost-effective Dual, Single supply type analogue multiplexer. The lowest voltage the electronic part should receive is 3V. For this multiplexer to operate, 1μA current would be sufficient. If put voltage greater than 8V on the multiplexer, damage may be caused to the device. When using dual power supplies, you should attach at least 3V. Operating voltages range from 12V. Don't miss this electronic component's additional features, such as: ALSO OPERATE WITH 3V TO 15V SINGLE SUPPLY.
MAX399EPE Features
4 Channels Switch Circuit: SP4T 1μA Supply Current Additional Features: ALSO OPERATE WITH 3V TO 15V SINGLE SUPPLY
MAX399EPE Applications
There are a lot of Maxim Integrated MAX399EPE Analog Switches & Multiplexers ICs applications.
Microprocessor Controlled Analog Systems
Sample hold systems
Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads