Packed in 16-SOIC (0.154, 3.90mm Width), the electronic component is convenient for shipping overseas. The advanced packaging method Tube provides high reliability. This analog switch is mounted in Surface Mount. Multiplexers and demultiplexers have a number of circuits 1:1. Operation at a temperature around 0°C~70°C TA. The total number of terminations is 16. A electrical component with 1 channels is capable of high-quality output. In the case of a voltage supply of 5V volts, the electrical part can be powered up and run. There are 16 pins injected into the electronic part body. Circuits based on SPST - NO/NC switching are used to construct these analog switch ics. This multiplexer is composed of 4 circuits. Try searching for MAX4523 variants of the analog switch ic. Analog switches have 100Ohm internal resistance. For details about the functions of 16 pins, please refer to the datasheets. Theswitch device is a typical Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 12V. Dual, Single supply type digital switch with a low cost. There should be 2V voltage fed to the electrical part below 2V. The analogue multiplexer could operate on 1μA current. If put voltage greater than 1μA on the device, damage may be caused to the analogue multiplexer. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 6V. For dual power supplies, a voltage of at least 2V should be attached. SEPARATE OUTPUT outputs are utilized by this digital multiplexer. 6V operating voltages can be used with this electrical part.
MAX4523CSE+ Features
1 Channels Switch Circuit: SPST - NO/NC 1μA Supply Current
MAX4523CSE+ Applications
There are a lot of Maxim Integrated MAX4523CSE+ Analog Switches & Multiplexers ICs applications.