MAX4613EUE+ Overview

Due to its 16-TSSOP (0.173, 4.40mm Width) packaging, the electronic part is convenient for international shipping. 1:1 is the ratio of multiplexer to demultiplexer circuits. Operation at a temperature around -40°C~85°C TA. A total of 16 terminations have been recorded. High-quality output is provided by the electronic component's 1 channels. A 15V voltage supply should turn on and run the electronic component. As part of the design of the 16 series, this electronic part has been incorporated into the system. On the other hand, analog switches can be constructed using SPST - NO/NC switching circuits. A total of 4 circuits make up this switch device. This digital multiplexer has 70Ohm internal resistance. To find out what the 16 pins do, please refer to the datasheets. There is a standard Multiplexer or Switches analogue multiplexer here. normally, users should not supply switches with voltages higher than 40V. 4.5V is the lowest voltage the electrical component should receive. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 20V. For dual power supplies, a voltage of at least 4.5V should be attached. In this switch multiplexer, there are SEPARATE OUTPUT outputs available.

MAX4613EUE+ Features

1 Channels
Switch Circuit: SPST - NO/NC

MAX4613EUE+ Applications

There are a lot of Maxim Integrated MAX4613EUE+ Analog Switches & Multiplexers ICs applications.

• Wireless Local Loop
• Digital access cross connects
• Precision data acquisition
• Cross Connects
• MP3 players
• Channelized and Unchannelized DS3 applications
• E1 Network Equipment
• Signal routing between systems
• 65 V DACs
• Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads