Packed in 10-TFSOP, 10-MSOP (0.118, 3.00mm Width), the electronic component is convenient for shipping overseas. Advanced packaging method Tube is used to provide high reliability. This analog switch is mounted in Surface Mount. The ratio between the number of multiplexer and demultiplexer circuits is 2:1. Extended operating temperature around -40°C~85°C TA. There are 10 terminations totally. By its 1 channels, the electronic component provides high-quality output. With a 1.8V voltage supply, the electrical component should be turned on and run. An electrical component of this type can be found in the 10 series. These analog multiplexers are built based on SPDT switching circuits. This multiplexer is composed of 2 circuits. If you are looking for variants of the digital switch, trying search with MAX4736. This digital multiplexer has 800mOhm internal resistance. Please refer to the datasheets for 10 pins functions. This switch device is a typical Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 3.6V. A cost-effective Single supply type analogue multiplexer. The lowest voltage fed to the electronic component should be 1.6V. 1μA current would be enough for this multiplexer to operate. Draining from a single voltage supply, this analog switch requires a voltage of 1.6V~4.2V. If put voltage greater than 1μA on the device, damage may be caused to the analogue multiplexer. This analog switch ic utilizes SEPARATE OUTPUT output. The electronic component can function from 3V. This switch operates within the bandwidth of 130MHz. This electronic component presents a Drain to Source resistance of 800mOhm.