74AHCT273D,112 Overview

It is embeded in 20-SOIC (0.295, 7.50mm Width) case. You can find it in the Tubepackage. There is a Non-Invertedoutput configured with it. In the configuration of the trigger, Positive Edgeis used. In this case, the electronic component is mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis required for its operation. In this case, the operating temperature is -40°C~125°C TA. D-Typeis the type of this D latch. FPGAs belonging to the 74AHCTseries contain this type of chip. Its output frequency should not exceed 75MHz Hz. A total of 1elements are present in it. T flip flop consumes 4μA quiescent energy. The number of terminations is 20. It is a member of the 74AHCT273 family. The power source is powered by 5V. Its input capacitance is 3pFfarads. In this case, the D flip flop belongs to the AHCT/VHCTfamily. In this case, the electronic component is mounted in the way of Surface Mount. This board has 20 pins. A Positive Edgeclock edge trigger is used in this device. This flip flop is designed with 8 Bits. For high efficiency, the supply voltage should be set to 5V. As of now, there are 8input lines.

74AHCT273D,112 Features

Tube package
74AHCT series
20 pins
8 Bits

74AHCT273D,112 Applications

There are a lot of Nexperia USA Inc. 74AHCT273D,112 Flip Flops applications.

• Frequency Dividers
• Bus hold
• Test & Measurement
• Synchronous counter
• Memory
• Instrumentation
• Counters
• Guaranteed simultaneous switching noise level
• Computers
• Modulo – n – counter