74ALVC16821MTD Overview

As a result, it is packaged as 56-TFSOP (0.240, 6.10mm Width). As part of the package Tube, it is embedded. As configured, the output uses Tri-State, Non-Inverted. It is configured with a trigger that uses Positive Edge. Surface Mountis positioned in the way of this electronic part. A voltage of 1.65V~3.6Vis required for its operation. It is operating at -40°C~85°C TA. The type of this D latch is D-Type. FPGAs belonging to the 74ALVCseries contain this type of chip. It should not exceed 250MHzin its output frequency. In total, it contains 2 elements. During its operation, it consumes 40μA quiescent energy. It is a member of the 74ALVC16821 family. There is 6pF input capacitance for this T flip flop. There is an electronic part mounted in the way of Surface Mount. There are 56pins on it. This device has the clock edge trigger type of Positive Edge. An electronic part designed with 20bits is used in this application. Using 20 circuits, it is highly flexible. There are 3 output lines on it. Currently, there are 10 input lines present. In this case, the high level output current is set to -24mA. In the low level output current setting, 24mAis used. The operating temperature should be lower than 85°C. A temperature above -40°Cshould be used for the operation. The minimum voltage required for operation is 1.65V. It supports the maximal supply voltage of 3.6V. The frequency that can be achieved is 200MHz.

74ALVC16821MTD Features

Tube package
74ALVC series
56 pins
20 Bits

74ALVC16821MTD Applications

There are a lot of ON Semiconductor 74ALVC16821MTD Flip Flops applications.

• Reduced system switching noise
• Single Down Count-Control Line
• Parallel data storage
• Instrumentation
• Individual Asynchronous Resets
• Modulo – n – counter
• Load Control
• Communications
• Latch-up performance
• High Performance Logic for test systems