74LVT574SJX Overview

The item is packaged in 20-SOIC (0.209, 5.30mm Width)cases. It is included in the package Tape & Reel (TR). In the configuration, Tri-State, Non-Invertedis used as the output. This trigger is configured to use Positive Edge. There is an electrical part that is mounted in the way of Surface Mount. Powered by a 2.7V~3.6Vvolt supply, it operates as follows. It is operating at -40°C~85°C TA. It is an electronic flip flop with the type D-Type. In this case, it is a type of FPGA belonging to the 74LVT series. You should not exceed 150MHzin its output frequency. The list contains 1 elements. There is a consumption of 190μAof quiescent energy. D latch belongs to the 74LVT574 family. This JK flip flop has a 4pFfarad input capacitance. Surface Mount mounts this electronic component. The 20pins are designed into the board. In this device, the clock edge trigger type is Positive Edge. The superior flexibility of this product is achieved by using 8 circuits. For high efficiency, the supply voltage should be set to 3.3V. To operate, the chip has a total of 3 output lines.

74LVT574SJX Features

Tape & Reel (TR) package
74LVT series
20 pins

74LVT574SJX Applications

There are a lot of ON Semiconductor 74LVT574SJX Flip Flops applications.

• Bounce elimination switch
• Communications
• Frequency Dividers
• Consumer
• Bus hold
• Shift Registers
• Load Control
• Registers
• Data storage
• High Performance Logic for test systems