DM74ALS74ASJ Overview
14-SOIC (0.209, 5.30mm Width)is the way it is packaged. The Tubepackage contains it. There is a Differentialoutput configured with it. In the configuration of the trigger, Positive Edgeis used. In this case, the electronic component is mounted in the way of Surface Mount. The JK flip flop operates at 4.5V~5.5Vvolts. Currently, the operating temperature is 0°C~70°C TA. Logic flip flops of this type are classified as D-Type. In FPGA terms, D flip flop is a type of 74ALSseries FPGA. You should not exceed 34MHzin the output frequency of the device. The element count is 2 . During its operation, it consumes 4mA quiescent energy. It is a member of the 74ALS74 family. There is an electronic component mounted in the way of Surface Mount. A total of 14pins are provided on this board. Its clock edge trigger type is Positive Edge. Flip flops designed with 2bits are used in this part. Its superior flexibility is attributed to its use of 2 circuits. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. It operates with 1 output lines. As of now, there are 1input lines. A high level output current of -400μAis set. In the low level output current setting, the current is set to 8mA. It is recommended that the operating temperature be below 70°C. Temperatures above 0°Cshould be used. The minimum voltage required for operation is 4.5V. 5.5Vis the maximum supply voltage supported by it. It is possible to obtain a frequency of 34MHz.
DM74ALS74ASJ Features
Tube package
74ALS series
14 pins
2 Bits
DM74ALS74ASJ Applications
There are a lot of ON Semiconductor DM74ALS74ASJ Flip Flops applications.
- High Performance Logic for test systems
- Consumer
- ESCC
- Dynamic threshold performance
- Bus hold
- Single Down Count-Control Line
- Clock pulse
- Divide a clock signal by 2 or 4
- Computers
- Single Up Count-Control Line
