FSA66L6X Overview

This electronic part is conveniently packaged in 6-UFDFN, making it easy to ship abroad. In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. Mounted in Surface Mount is this multiplexer. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. Operating temperature around -40°C~85°C TA extended. A high-quality output is provided by the electrical component's 1 channels. A SPST - NO switching circuit is used for these analog switches. Try searching with FSA66 if you're looking for variants. An switch multiplexer with 15Ohm internal resistance has a value of 15Ohm. To find out what the 6 pins do, please refer to the datasheets. A voltage higher than 5.5V should not normally be supplied to the switches. An effective Single supply digital multiplexer. It is recommended that the electrical component receives a voltage of 1.65V. This analogue multiplexer requires a voltage of 1.65V~5.5V when it drains from a single voltage supply. If put voltage greater than 10μA on the device, damage may be caused to the analogue multiplexer.

FSA66L6X Features

1 Channels
Switch Circuit: SPST - NO
-3db Bandwidth: 250MHz

FSA66L6X Applications

There are a lot of ON Semiconductor FSA66L6X Analog Switches & Multiplexers ICs applications.

• Video signal routing
• Microwave transmission systems
• Sample hold systems
• Cellular phones
• Access Concentrators
• E1 Network Equipment
• PBXs
• Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
• Cell phones
• Video switching