MC100EP29DTG Overview
It is packaged in the way of 20-TSSOP (0.173, 4.40mm Width). Package Tubeembeds it. Currently, the output is configured to use Differential. This trigger is configured to use Positive, Negative. Surface Mountis occupied by this electronic component. A supply voltage of -3V~-5.5V is required for operation. A temperature of -40°C~85°C TAis used in the operation. There is D-Type type of electronic flip flop associated with this device. In terms of FPGAs, it belongs to the 100EP series. This D flip flop should not have a frequency greater than 3GHz. It consumes 57mA of quiescent current without being affected by external factors. There are 20 terminations,D latch belongs to the 100EP29 family. A voltage of 3.3V is used as the power supply for this D latch. The electronic part is mounted in the way of Surface Mount. As you can see from the design, it has pins with 20. There is a clock edge trigger type of Positive Edgeon this device. This device is part of the FF/Latchesbase part number family. There is a 5.5Vmaximum supply voltage (Vsup). The supply voltage (Vsup) should be kept above 3V for normal operation. Despite its superior flexibility, it relies on 2 circuits to achieve it. On the basis of its reliable performance, this D flip flop is well suited for use with RAIL. There are -4.5V power supplies attached to it. Featuring the maximum design flexibility, it has an output current of 50mA . Additionally, you may refer to the additional NECL MODE: VCC = 0V WITH VEE = -3V TO -5.5V of the electronic flip flop. A -50mAvalue is set for the high level output current. 50mAis set as the low level output current.
MC100EP29DTG Features
Tube package
100EP series
20 pins
-4.5V power supplies
MC100EP29DTG Applications
There are a lot of ON Semiconductor MC100EP29DTG Flip Flops applications.
- Buffer registers
- Divide a clock signal by 2 or 4
- Balanced 24 mA output drivers
- Single Down Count-Control Line
- Data transfer
- CMOS Process
- Counters
- Computing
- Modulo – n – counter
- ESD performance
