MC10EL31DR2G Overview

The flip flop is packaged in a case of 8-SOIC (0.154, 3.90mm Width). D flip flop is included in the Tape & Reel (TR)package. The output it is configured with uses Differential. The trigger configured with it uses Positive Edge. There is an electronic component mounted in the way of Surface Mount. A -4.2V~-5.7Vsupply voltage is required for it to operate. A temperature of -40°C~85°C TAis considered to be the operating temperature. This electronic flip flop is of type D-Type. The 10ELseries comprises this type of FPGA. It should not exceed 2.8GHzin terms of its output frequency. There is 32mA quiescent consumption. A total of 8 terminations have been made. If you search by 10EL31, you will find similar parts. The D flip flop is powered by a voltage of 5V . It is mounted in the way of Surface Mount. The 8pins are designed into the board. Its clock edge trigger type is Positive Edge. The part you are looking for is included in FF/Latches. An electronic part designed with 1bits is used in this application. In this case, the maximum supply voltage (Vsup) reaches 5.7V. For normal operation, the supply voltage (Vsup) should be kept above 4.2V. Using 1 circuits, it is highly flexible. This D flip flop is well suited for TAPE AND REEL based on its reliable performance. It operates from -5.2V power supplies. Additionally, you may refer to the additional NECL MODE: VCC = 0V WITH VEE = -4.2V TO -5.7V of the electronic flip flop. 50mA is set as the high level output current. Low level output current is set to 50mA.

MC10EL31DR2G Features

Tape & Reel (TR) package
10EL series
8 pins
1 Bits
-5.2V power supplies

MC10EL31DR2G Applications

There are a lot of ON Semiconductor MC10EL31DR2G Flip Flops applications.

• Functionally equivalent to the MC10/100EL29
• Matched Rise and Fall
• 2 – Bit synchronous counter
• ESCC
• Latch-up performance
• Data Synchronizers
• Data storage
• Digital electronics systems
• Frequency Dividers
• Single Up Count-Control Line