MC74HC273ADTG Overview

As a result, it is packaged as 20-TSSOP (0.173, 4.40mm Width). D flip flop is embedded in the Tube package. In the configuration, Non-Invertedis used as the output. It is configured with the trigger Positive Edge. There is an electronic component mounted in the way of Surface Mount. Powered by a 2V~6Vvolt supply, it operates as follows. Currently, the operating temperature is -55°C~125°C TA. This electronic flip flop is of type D-Type. FPGAs belonging to the 74HCseries contain this type of chip. You should not exceed 35MHzin the output frequency of the device. In total, there are 1 elements. It consumes 4μA of quiescent current without being affected by external factors. The number of terminations is 20. The 74HC273 family contains it. Power is provided by a 3V supply. The input capacitance of this T flip flop is 10pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. An electronic device belonging to the family HC/UHcan be found here. It is mounted by the way of Surface Mount. It is designed with 20 pins. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. The part you are looking for is included in FF/Latches. There are 8bits in its design. It reaches 6Vwhen the maximum supply voltage (Vsup) is applied. Normally, the supply voltage (Vsup) should be kept above 2V. As a result of its reliability, this D flip flop is ideally suited for RAIL. The system runs on a power supply of 2/6V watts. Featuring the maximum design flexibility, it has an output current of 7.8mA . It has 8 output lines to operate. There are 8 channels available.

MC74HC273ADTG Features

Tube package
74HC series
20 pins
8 Bits
2/6V power supplies

MC74HC273ADTG Applications

There are a lot of ON Semiconductor MC74HC273ADTG Flip Flops applications.

• Computers
• Divide a clock signal by 2 or 4
• Storage registers
• QML qualified product
• Event Detectors
• Functionally equivalent to the MC10/100EL29
• Single Down Count-Control Line
• Pattern generators
• Guaranteed simultaneous switching noise level
• Dynamic threshold performance