MC74VHCT573ADTR2 Overview

It is embedded in the 20-TSSOP (0.173, 4.40mm Width) package. Packaged in the way of Tape & Reel (TR). The output it is configured with uses Tri-State. A D-Type Transparent Latch logic type is used in this electrical device. A Surface Mount mount is used for mounting this electronic part. A voltage of 4.5V~5.5V is used as the supply voltage for this device. There is -40°C~85°C operating temperature. In the 74VHCT series, this FPGA is located. The design of this electronic part is based on 8 bits. A device such as this has 20 terminations designed. The family in which it belongs to is 74VHCT573. With the supply voltage set at 5V, it is able to operate. It has 20 pins that makes it easy to use. It is a member of the AHCT/VHCT family of electronic devices. With the design of the board, there are only 20 pins. Surface Mount is used to mount this electronic part. This device is equipped with 2 ports. In the subcategory FF/Latches, this part belongs. A total of 5V power supplies are needed to run it. It consists of 8 input lines from which an electronic circuit can be built. On the basis of its reliability, this device is well suited for TAPE AND REEL. A high efficiency supply voltage should be maintained at 5V. 3 output lines provide binary equivalents of input lines.

MC74VHCT573ADTR2 Features

20-TSSOP (0.173, 4.40mm Width) package
74VHCT series
8 Bits
74VHCT573 family
20 pin count
20 pins
5V power supplies

MC74VHCT573ADTR2 Applications

There are a lot of ON Semiconductor MC74VHCT573ADTR2 Latches applications.

• Counters
• Up/down difference counting
• Four-bit storage with output enable
• Automotive ADAS
• Instrumentation
• Watches
• Automotive HEV/EV Powertrain
• Motor Drives
• Serial Output Data Queuing
• Stacked or Push-Down Registers