NLAS4717EPMTR2G Overview

Shipping overseas is convenient with the electronic component packed in 10-WFQFN. High reliability is provided by advanced packaging method Tape & Reel (TR). In Surface Mount, this analog switch is mounted. Multiplexers and demultiplexers have a ratio of 2:1. Temperatures around -40°C~85°C TA are extended for operation. Total terminations are 10. High-quality output is provided by the electronic component's 2 channels. If the voltage supply is 3V volts, the electrical component should be turned on and run. The electronic part body is injected with 10 pins. A SPDT switching circuit is used to build these analog multiplexers. Try searching with NLAS4717 if you're looking for variants. There is 4.5Ohm internal resistance in this digital multiplexer. For functions related to 10 pins, please refer to the datasheets. Theswitch device is a typical Multiplexer or Switches. A voltage higher than 5.5V should not normally be supplied to the switches. Analogue multiplexers of the Single supply type that are cost-effective. 1.8V should be the lowest voltage fed to the electronic component. For this multiplexer to operate, 1μA current would be sufficient. This analog switch requires a voltage of 1.8V~5.5V to drain from a single voltage supply. The analogue multiplexer may be damaged if voltage is greater than 1μA. 3V operating voltages are supported by the electronic component. The analogue multiplexer has 4 outputs.

NLAS4717EPMTR2G Features

2 Channels
Switch Circuit: SPDT
1μA Supply Current
-3db Bandwidth: 90MHz

NLAS4717EPMTR2G Applications

There are a lot of ON Semiconductor
NLAS4717EPMTR2G Analog Switches & Multiplexers ICs applications.

• Transmit
• Low-Voltage
• Isolation
• Medical
• Imaging
• Ultrasound
• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems