Shipping overseas is convenient due to the electrical component's packing in 10-TFSOP, 10-MSOP (0.118, 3.00mm Width). High reliability is achieved by using advanced packaging method Tape & Reel (TR). This analog switch is mounted in Surface Mount. The ratio between the number of multiplexer and demultiplexer circuits is 2:1. Extended operating temperature around -40°C~85°C TA. In total, 10 terminations have occurred. The electronic part delivers high-quality output through its 1 channels. If the voltage supply is 3V volts, the electrical component should be turned on and run. Electronic part bodies are injected with 10 pins. Based on SPDT switching circuits, these analog multiplexers work. The multiplexer consists of 2 circuits. Try searching with NLAS4717 to find analog multiplexer variants. An switch multiplexer with 2.1Ohm internal resistance has a value of 2.1Ohm. To find out what the 10 pins do, please refer to the datasheets. There is Multiplexer or Switches analog multiplexer like this in the world. In normalcircumstances, users should not exceed 5.5V volts for the multiplexer. A cost-effective Single supply type analogue multiplexer. The lowest voltage the electronic part should receive is 1.8V. It would be sufficient to run this analogue multiplexer with 1μA current. A voltage of 1.8V~5.5V is required to drain this analog switch from a single voltage supply. Putting voltage greater than 1μA on the multiplexer may cause damage. This analog switch ic utilizes SEPARATE OUTPUT output. 5V operating voltages can be used with this electrical part.