Packed in 10-TFSOP, 10-MSOP (0.118, 3.00mm Width), the electronic component is convenient for shipping overseas. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). Multiplexers like this are mounted in the Surface Mount position. Multiplexers and demultiplexers have a ratio of 2:1. Operating temperature around -40°C~85°C TA extended. Total terminations are 10. As a result of its 2 channels, this electronic component provides high-quality output. If the voltage supply is 3V volts, the electrical component should be turned on and run. A key feature of the 10 series is the inclusion of this electronic part as part of its design. On the other hand, analog switches can be constructed using SPDT switching circuits. Try searching with NLAS4717 to find analog multiplexer variants. Analog switches have 2.1Ohm internal resistance. The functions of 10 pins can be found in the datasheets. There is a standard Multiplexer or Switches analogue multiplexer here. Multiplexers should not be powered above 5.5V in normal situations. Single supply type digital switch with a low cost. 1.8V is the lowest voltage the electrical component should receive. The analogue multiplexer could operate on 1μA current. This analog switch requires a voltage of 1.8V~5.5V to drain from a single voltage supply. The analogue multiplexer may be damaged if voltage is greater than 1μA. This digital multiplexer has 4 outputs.