L2722 Overview
In order to protect the op amps, a 8-DIP (0.300, 7.62mm) case is used. General Purpose-type instrumentation amplifiers are used in this application. In the case of Tube cases, linear amplifier will be delivered. There have been a total of 8 terminations over the past year. In total, there are 8 pins on this op amp ic. The linear amplifier should be run at 24V at all times, so please keep that in mind when using it. In order to be more specific, this instrumentation amplifier is one of the types of Operational Amplifier devices. The op amp ic has an array of 8 pins on it. As far as the input offset voltage is concerned, linear amplifier rates at 10mV. For this electrical component, the recommended mounting type is Through Hole, which is the most common. You can run this op amp ic on 10mA . There should be no change in the voltage gain. There are 2 channels on the operational amplifiers. For the buffer op amp to operate properly, it must be above the temperature of -40°C degrees Celsius. No temperature greater than 150°C should be used. The operating supply voltage of the buffer op amp is rated at 14V.
L2722 Features
8 Pins
supply voltage of 24V
80dB voltage gain
L2722 Applications
There are a lot of STMicroelectronics L2722 Instrumentational OP Amps applications.
- Radiation thermometry transducers
- Band-pass filter
- Communication
- Test and measurement instruments
- Fission chambers
- Television broadcasting equipment
- Addition operation circuits
- High-frequency data acquisition systems
- Weak signal detection
- Subtraction operation circuits
