LF253D Overview
Packaged in a 8-SOIC (0.154, 3.90mm Width) case, the buffer op amp is ready to use. The instrumentation amplifier in this picture is of the J-FET-type. As far as the packaging is concerned, buffer op amp is delivered in a Tube case. A total of 8 terminations have been reported in the past few weeks. It consists of a total of 8 pins in total. I would like to remind you that this buffer op amp should be powered by an 15V battery. To be specific, this instrumentation amplifier is a type of Operational Amplifier. A total of 8 pins are present on the instrumentation amplifier. With regards to the offset voltage of the input, buffer amplifier is rated at 3mV. Surface Mount is the recommended mounting type for this linear amplifier. In terms of operating temperatures, this buffer amplifier works very well at a temperature of around -40°C~105°C . The buffer amplifier is capable of operating from a supply current of 1.4mA . There should be no change in the voltage gain at 106.02dB. A linear amplifier like this has 2 circuits on it. The operating supply voltage of the buffer op amp is rated at 18V.
LF253D Features
8 Pins
supply voltage of 15V
106.02dB voltage gain
LF253D Applications
There are a lot of STMicroelectronics LF253D Instrumentational OP Amps applications.
- Proportional operation circuits
- Medical instruments
- Signal amplification
- Measurements of Wheatstone bridge
- Active probe
- High/low-pass filter circuit
- Car stereo
- earphone
- Ultrasound transducers
- Fission chambers
